English
ONLINE SHOPPING IN IMN:
- Visit IMN Therapy Centre at L'Avenue Office Building@ Pancoran
- CPAP Trial is available
- Online order @ IMN Tokopedia store
OXYGEN HUMIDIFIER BOTTLE INSTRUCTIONS
Oxygen is a dry gas and a humidifier bottle may be used to help alleviate a sore, dry and/or bloody nose. The oxygen picks up humidity by flowing through a water bottle connected to the concentrator or liquid system.
Directions for use
1. Fill the humidifier bottle with distilled water to the maximum fill line.
Do not overfill.
2. Attach the humidifier cap to the bottle. Tighten carefully making sure to thread the cap and bottle snugly. Avoid cross threading as this will cause a leak.
3. Depending on the machine you have, attach the inlet nut to the oxygen outlet or humidifier adaptor on the oxygen system and hand tighten. If the inlet nut or adaptor are cross threaded, oxygen will leak out.
4. Test the humidifier for leaks by setting the flowrate at 4 liters (or higher) and block the humidifier outlet. The safety valve should “pop”or “whistle” within 15 seconds. If it does not, check the bottle and lid to assure they are tight and repeat the test.
5. After the humidifier bottle is attached properly, connect your extension tubing to the humidifier outlet, and turn the flow rate to your prescribed level.
Instructions to blow water out of extension tubing
1. Disconnect the oxygen tubing from the humidifier bottle
2. Connect oxygen tubing to a continuous flow source, the concentrator or a back up tank.
3. Increase liter flow to maximum setting of airflow. This will force the water out of the tubing in a short period of time.
4. Once the tubing is clear of water, turn flow to correct setting, or regulator to the off position.
5. Reinstall oxygen tubing to the humidifier bottle or directly to the concentrator.
Once a week, disconnect the humidifier bottle and clean with soapy water, rinse well and refill with distilled water.
Caution: It is extremely important that you assemble the humidifier bottles correctly to avoid any leaks or you may not be receiving the amount of oxygen prescribed.
Bahasa Indonesia
BELANJA ONLINE DI IMN:
- Kunjungi pusat terapi IMN di L'Avenue Office Building@ Pancoran
- Tersedia ujicoba CPAP
- Untuk pemesanan online, silakan kunjungi Tokopedia official store kami di Indo Medika Nusantara (IMN) atau bisa juga melalui WhatsApp kami.
PETUNJUK BOTOL PELEMBAB OKSIGEN
Oksigen adalah gas kering dan botol pelembap dapat digunakan untuk membantu meringankan hidung yang sakit, kering dan/atau berdarah. Oksigen mengambil kelembapan dengan mengalirkannya melalui botol air yang terhubung ke konsentrator atau sistem cairan.
Petunjuk penggunaan pelembap udara sebagai berikut:
1. Isi botol pelembap udara dengan air suling sampai garis pengisian maksimum, jangan sampai terisi penuh.
2. Pasang tutup pelembap ke botol. Kencangkan dengan hati-hati, pastikan tutup dan botol terpasang dengan benar. Hindari penguliran silang, karena akan menyebabkan kebocoran.
3. Pasang mur saluran masuk ke saluran keluar oksigen atau adaptor pelembap pada sistem oksigen, kencangkan dengan tangan. Hindari penguliran silang agar tidak terjadi kebocoran.
4. Uji pelembap udara dengan mengatur debit aliran pada 4 liter atau lebih tinggi, dan tutup saluran keluar pelembap udara. Dalam waktu 15 detik, katup pengaman seharusnya "meletus" atau "bersiul". Jika tidak, periksa botol dan tutupnya, pastikan kencang dan ulangi pengujiam.
5. Setelah botol pelembap terpasang dengan benar, sambungkan selang ekstensi ke stopkontak pelembap dan sesuaikan laju aliran sesuai kebutuhan.
Petunjuk untuk meniupkan air keluar dari tabung ekstensi
1. Lepaskan selang oksigen dari botol pelembab udara
2. Sambungkan selang oksigen ke sumber aliran kontinu, konsentrator, atau tangki cadangan.
3. Tingkatkan aliran liter ke pengaturan aliran udara maksimum. Hal ini akan memaksa air keluar dari tabung dalam waktu singkat.
4. Setelah pipa bersih dari air, putar aliran ke pengaturan yang benar, atau regulator ke posisi mati.
5. Pasang kembali selang oksigen ke botol pelembab atau langsung ke konsentrator.
Seminggu sekali, lepaskan botol pelembab udara dan bersihkan dengan air sabun, bilas bersih dan isi ulang dengan air suling.
Perhatian: Sangatlah penting bagi Anda untuk memasang botol pelembap udara dengan benar untuk menghindari kebocoran atau Anda mungkin tidak menerima jumlah oksigen yang ditentukan.